Sunday, January 22, 2012

TCS Z2 in an older Atlas RS11

This is an old engine without the LED lights, flywheels, low friction trucks, or Micro-Trains ready coupler pockets that we have become accustomed to.  At about the time DCC started to catch on with N scalers in the early 1990's, this was a very common mechanism that was used on several models made for Atlas by Kato in the mid to late 1980's.   They do have a good motor, and with a DCC decoder momentum can be programmed to help make up for the lack of flywheels.


First step is to take the engine apart.  Getting the shell off is the hardest part.  Here's the trick.  First remove the cab to expose the catches that hold the shell to the frame.







Once the cab is off, the main part of the shell can be easily removed as shown in this photo.







This photo shows all of the parts after this RS11 has been dis-assembled.

This mechanism is almost identical for the Kato made Atlas RS3, RS11, RSD4/5, RSD12, GP7, and GP9.





Here are the lengths that I cut the decoder wires to.

2" - White
1-7/8" - Red & Black
1-3/4" - Orange
1-1/4" - Gray
7/8" - Yellow & Blue


This photo shows the decoder wires solder to the modified light boards and the motor brush caps.


The next two photos show the details of the light boards.

The PC boards are the same as the common Kato 77A board.  It's just that these have a light bulb and a diode instead of a LED and resistor.  The directional lighting will be determined by the decoder so the diodes are not needed.

The red and black wires from the decoder will make their connection to the frame from this board.




On the rear light board I cut off the tabs with a Dermal tool, removed the diode and soldered the blue and yellow wires from the decoder to the light.  Polarity will not matter with the light bulb.  A second blue wire was run between this board and the front board.










Re-install the brush caps with the brushes and springs on the motor.  Then place the motor assembly into the left side frame as shown in this photo.  This one did not have any separate worm gears or bushings, it was all attached to the motor.










Here is the completed DCC mechanism.  As you can see, there is lots of room for the decoder.  Any of the small wired N or Z scale decoders could fit in this space.



Finishing Touch

These older engines had truck mounted Rapido couplers with big openings on the pilots.

Micro-Trains made pilot conversion kits and these are still available.  For the RS11 look for Micro-Trains part number 1150.

3 comments:

  1. Thanks Brad. Just wondering if a DZ125 can be installed the same way as you did for the LL Switcher on the RS11 or RS3.

    Your decoder blog will compliment Spookshows locomotive encyclopedia extremely well. Thanks a million.

    ReplyDelete
    Replies
    1. The narrowness of the Z2 allows the original board to be used to make contact to the frame on the LL Switcher. I have used DZ125's but then had to make contact to the frame using the screws that hold the frame together to hold the wires. I prefer using the Z2.

      The DZ125 should work as a fine subtitute for the Z2 on the older Atlas RS3's and RS11's.

      Hope this helps and thank you for being the first commenter on this blog.

      Delete
  2. Thanks, Brad. :)

    I hang around at www.nscale.org. Passed on your blog to couple of my friends over there.

    Currently decodering a Shay with a DZ125. Not much space in there. Trying to reduce the space requirements with SMD resistors for lights (0603 SMD LED's). Very challenging install to put it that way. ;-)

    ReplyDelete